">

Click here to check out our new How To section">Click here to check out our new How To section

Skip to end of banner Go to start of banner

Outside Size Too Big

Skip to end of metadata

Created by dani.simmonds, last modified on Oct 15, 2024

Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Outside Size Too Big

If the Outside is cut Too Large, Decrease the Opening Adjustment.

The Opening Adjustment controls the size of the Opening cut or applied with non-blade cartridges.
- If Opening cuts Too Large, Decrease the Opening Adjustment.
- If Opening cuts Too Small, Increase the Opening Adjustment.

Full Definition: Opening Adjustment Definition

For Additional Information: Troubleshooting Utility for the Configurations

How to Adjust the Opening Adjustment

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

No labels