Crease Cartridge Configurations

The Crease Cartridge is used to apply Perforation marks that are used to assist in folding the thicker finished Box.

The Backup controls where the Blade Plunges into the Matboard (not the Fallout) on the Exterior cuts of Openings. 

If the Backup is cut Too Long, Decrease the Backup.

If the Backup is cut Too Short, Increase the Backup.

The Backup field is marked with a Green Arrow on the Configuration screen and the Map illustration.

See: Backup for Creases.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

The Backup controls where the Blade Plunges into the Matboard (not the Fallout) on the Exterior cuts of Openings. 

If the Backup is cut Too Long, Decrease the Backup.

If the Backup is cut Too Short, Increase the Backup.

The Backup field is marked with a Green Arrow on the Configuration screen and the Map illustration.

See: Backup for Creases.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

The Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cuts of Openings.

If the Overcut is cut Too Long, Decrease the Overcut.

If the Overcut is cut Too Short, Increase the Overcut.

The Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

See: Overcut for Creases.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

The Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cuts of Openings.

If the Overcut is cut Too Long, Decrease the Overcut.

If the Overcut is cut Too Short, Increase the Overcut.

The Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

See: Overcut for Creases.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

The Opening Adjustment controls the size of the Opening cut or Object applied with non-blade cartridges.

If the Crease is Too Large, Decrease the Opening Adjustment.

If the Crease is Too Small, Increase the Opening Adjustment.

See: Opening Adjustment for Creases.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

The Depth Bias is used to calculate the proper Blade Depth when the SKU selected for the matboard contains the Matboard Thickness.

If the Blade Depth is cut Too Deep, Decrease the Depth Bias.

If the Blade Depth is cut Too Shallow, Increase the Depth Bias.

The formula is: [(Default Depth) - 10]

For example, if the normal Blade Depth for 4-ply is 11, then 11-10=1, so enter 1 for the Depth Bias.

See: Depth Bias

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

The Troubleshooting Utility allows you to bring in a single opening and automatically selects the correct Cartridge tab and Bevel Type to configure.