Opening Adjustment on V-Grooves

For Additional Information: See Troubleshooting Utility for information on adjusting the object’s size.

How to Select the Bevel Type to Edit

Select the desired Bevel Type from Current Bevel Type.

Edit the desired Configuration field.

How to Adjust the Opening Adjustment

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

Cutting Direction of V-Grooves
First Cut: Cuts the Interior cut into the Fallout Clockwise. Second Cut: Cuts the Exterior cut into the Matboard Counter-Clockwise.

V-Groove Size too Big

For Additional Information: See Troubleshooting Utility for information on adjusting the object’s size.

Opening Adjustment on V-Grooves Definition

The Opening Adjustment controls the size of the Opening cut or Object applied with non-blade cartridges.

If the V-Groove is cut Too Large, Decrease the Opening Adjustment.

How to Adjust the Opening Adjustment

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

For Additional Information: See Troubleshooting Utility for information on adjusting the object’s size.

Opening Adjustment on V-Grooves Definition

The Opening Adjustment controls the size of the Opening cut or Object applied with non-blade cartridges.

If the V-Groove is cut Too Small, Increase the Opening Adjustment.

How to Adjust the Opening Adjustment

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

For Additional Information: See Width Adjustment for information on adjusting the Width of the V-Groove.

Width Adjustment Definition

The Width Adjustment controls the Width of the V-Groove Lines.

If the V-Groove is cutting Too Thin, Increase the Width Adjustment.

If the V-Groove is cutting Too Wide, Decrease the Width Adjustment.

See: Width Adjustment

Opening Adjustment in the Troubleshooting Screen
For Additional Information: See Troubleshooting Utility for information on adjusting the object’s size. Enter the measured height and width of the opening into the appropriate fields and clicking the Calc Opening Adjustment button. Make sure that only a single opening is present on the screen, otherwise the Troubleshooting Button will be grayed out.