">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 8 Next »

See Trace Lesson Eleven: Starburst for the first half of this lesson.

To Rotate the Starburst in Trace:

*See Determining the Degree of Rotation for information on how to determine the optimum degree of rotation for your particular CutArt.

  • Click the Rotate button.

  • The CutArt will rotate.

Trace, Save, Cut

  • Save the CutArt. You will get a message stating that this design contains objects that do not have an assigned bevel type. This refers to the alignment lines that we didn't trace. Click Yes that you wish to continue. 

  • The CutArt is saved.

  • Load the CutArt into the Design editor.

  • Cut the CutArt.

  • Since it is a Deboss design, you can also size it much smaller if desired without worrying about overcuts and backups

  • Optionally, you can also bring the CutArt straight to the Cut Preview from Trace.

  • The starburst design is completed.

Comparison

You can see how much we changed the design when you compare it to what we started with. You can alter the design greatly by changing the number of sides of the template, selecting a different template, changing the CutArt placed, and even the number of degrees of rotation when you place it on the Editor. 

  • No labels