">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 17 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

45 Degree Plus Cartridge Configurations

  • The 45 Degree Plus Cartridge cuts a 45° bevel into thicker matboard such as 8-ply. 

  • Older systems may have a yellow plastic 45°+ Cartridge.

Select the 45 Degree Plus Cartridge Bevel Type

  • Below is a list of support documentation for editing the configurations of the 45 Plus Degree Bevel Cartridge on the 45 Plus Degree Tab.

45 Degree Plus Opening Configurations

Select this topic to see information on editing the configurations for the 45 Degree Plus Opening, including:

  • Normal Bevel

  • Reverse Bevel

  • Normal Bevel-Front of Mat

  • Reverse Bevel-Front of Mat

45 Degree Plus Drop Configurations

Select this topic to see information on editing the configurations for the 45 Degree Plus Drop, including:

  • Normal Drop

  • Reverse Drop

  • Normal Drop-Front of Mat

  • Reverse Drop-Front of Mat

45 Degree Plus Outside Configurations

Select this topic to see information on editing the configurations for the 45 Degree Plus Outside, including:

  • Outside

  • Outside-Front of Mat

45 Degree Plus V-Groove Configurations

Select this topic to see information on editing the configurations for the 45 Degree Plus V-Groove.

  • V-Groove

Troubleshooting Button

Select this topic to see information on the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview.

  • No labels