changes.mady.by.user dani.simmonds
Saved on yesterday at 7:33 pm
Saved on yesterday at 7:34 pm
Select Start with Settings to preset settings for each Cut session.
Select Start With Settings to use preset toggle settings.
Select Remember Previous to use the setting used on the previous session.
90 Degree Outside Cut: Cut Preview Set Advanced Options
Adjusting the 90 Degree Cartridge Cut Speed for Extra Dense Material
Air Pressure for Cutting with the 90 Degree Cartridge
Auto Offset Display
Continuous Layer: Cut Preview Options
Continuous Layer Display
Continuous Layer Options Menu: Cut Preview
Cut From Back: Cut From Front Toggle Off: Cut Preview Options
Cut Front Tool: Always Use Normal Tool Options Menu: Cut Preview
Cut Front Tool: Switch Between Front and Normal Tools Options Menu: Cut Preview
Cut From Front: Cut From Front Toggle On: Cut Preview Options
Cut From Front Display
Cut From Front Options Menu: Cut Preview
Cut Side Specifications in the Configurations
Cut the Outside: Cut Preview Toggle
Cut Outside Options Menu: Cut Preview
Cut the Outside Display
Cut Speed Percentage: Cut Speeds Screen
Cutting an Extra Dense Layer with the 90° Cartridge
Disable Auto Offset: Location Tab
Enable Auto Offset: Location Tab
Enable Outside Cut: Cut Preview Set Advanced Options
Matboard: Cut the Outside Editor Properties Tab
Matboard: Cut the Outside as a Rectangle: Properties Tab
Matboard: Cut the Outside as an Oval: Properties Tab
Matboard: Not Cut the Outside Editor Properties Tab
Outside Cut Off: Cut Mode Advanced Options
Outside Cut Off: Cut Preview Outside Cut Options
Outside Cut Shared Edge: Cut Preview Outside Cut Options
Selecting the 45 Degree Front Cartridge in the Cut Preview Screen
Selecting the 90 Degree Cartridge in the Editor
Selecting the 90 Degree Cartridge Outside Cut: CMC 8500eSBT, 9000 and 8000+
Selecting the 90 Degree Cartridge Outside Cut: CMC Z Series
Shared Edge: Cut Mode Advanced Options
Variable Pressure Optimization (VPO) Feature
90 Degree Outside: Cutting Default Setting
Auto Offset: Cutting Default Setting
Continuous Layer: Cutting Default Setting
Cut From Front Blade Cartridge Selection: Cutting Default Setting
Cut From Front: Cutting Default Setting
Cut the Outside: Editor Default Setting
Remember Previous Cut Settings: Cutting Default Setting
Setting the 45 Degree Front Cartridge Default Setting
Shared Edge Cut Mode: Cutting Default Setting
Start With Cut Settings: Cutting Default Setting
