Page Comparison

Note: Not all cartridges are available for all CMC models.

• To adjust, click Plus/Minus on the desired field about five times.

• Click OK and do another test cut.

• Continue making adjustments until the desired outcome is achieved.

• The Outside Non-Oval V-Groove cuts with a Swoop or Flare.

• Use the Troubleshooting Configurations to fine-tune for Swoop/Flare in a Non-Oval V-Groove.

The Outside Rotation on Non-Oval V-Grooves controls for Swoops and Flares in the Outside Cut of the Non-Oval V-Grooves.

First Cut of V-Groove:

• Cuts the Interior V-Groove Line.

• Cuts into Fallout, not the matboard.

• Cuts Clockwise.

• This uses the Inside Rotation.

Second Cut of V-Groove:

• Cuts the Exterior V-Groove Line.

• Cuts into Matboard, not the fallout.

• Cuts Counter-Clockwise.

• This uses the Outside Rotation.

• The Outside cut of the Non-Oval V-Groove has Swoops.

• If the Outside Non-Oval V-Groove cuts with a Swoop, Decrease the Outside Rotation.

• The Outside cut of the Non-Oval V-Groove has Flares.

• If the Outside Non-Oval V-Groove cuts with a Flare, Increase the Outside Rotation.