Versions Compared

Old Version 5

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version Current

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Change to the 45 Plus Degree Blade Cartridge

Info

  • The 45°+ Cartridge cuts the Bevel Angle on the thicker matboard at 45°.

    • The 45°+ Blade Cartridge supports Blade Depths above 16.

  • The Black 45°+

black metal blade cartridge* is labeled + on the

  • Blade Cartridge is labeled with a 45° Angle Symbol and Plus Symbol on the Cartridge end.

    • *Older systems may have a 45°+

yellow plastic cartridge

    • Yellow Plastic Blade Cartridge. 

Image RemovedPush blade cartridge release

End45PlusCartridge70800.pngImage Added
Info

  • Your hardware may look different than the model pictured, but the process is still the same.

  • Push the Blade Cartridge release lever down to eject the

current blade cartridge.Turn 45 Plus degree cartridge over and reinsert into the head with the blade facing the CMC board

  • Blade Cartridge.

Image Added

  • Insert the new Cartridge into the Head with the Blade facing toward the Board and the notch on the back of the

cartridge

  • Cartridge facing the

head, until it clicks into place. It can only be inserted one way.Image RemovedTurn cartridge over and reinsert into the head with the blade facing the CMC board and the notch on the back of the cartridge facing the head, until it clicks into place.

  • Head.

  • It should click into place.

    • It can only be inserted one way.

  • If there is side-to-side movement of the blade in the blade cartridge, or if chunks have been cut out of it, then it is time to replace the blade cartridge.

    • Image Removed
    Image Added