Positioning Controls
If desired, use the Positioning Control Arrows to move the design one-mat-width with each click.
This allows the user to cut several of the test mats from a full sheet of matboard as you calibrate the circles.
It shows the full sheet of matboard with a representation of the last mat cut displayed.
When you have finished calibrating your circles, click OK to return to the Configurations Screen when done.
| Panel | ||||||||
|---|---|---|---|---|---|---|---|---|
| ||||||||
|
Circle/Oval Rotation Utility | |||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
If the Oval Opening has a Feather, Decrease the Oval Rotation.
Expand | | ||||||||||||||||||
|  | ||||||||||||||||||
Circle/Oval Rotation Screen
Testing the Circle Cuts
Select the Bevel Type Cutting Direction for the bevel type you are editing from the upper left dropdown control.
| Panel | ||||||||
|---|---|---|---|---|---|---|---|---|
| ||||||||
|
Put in an 11x12" mat into the CMC and click Cut.
Align the Head if necessary.
After it cuts, check the cuts and determine if you are getting a Bump or a Feather for any of the oval sizes that were cut.
Bump
| title | Bumps Oval Rotation General Definition |
|---|
The Oval Rotation controls for Bumps or Feathers on an Oval Opening.
See: Oval Rotation Configurations
See: Oval Rotation for Openings Configurations
See: Oval Rotation for Drops Configurations
See: Oval Rotation for the Outside Configurations
See: Outside Oval Rotation for V-Grooves Configurations
See: Inside Oval Rotation for V-Grooves Configurations
Feather
If the Oval Opening has a Feather, Decrease the Oval Rotation by moving the slider to the left.
| Expand | ||
|---|---|---|
| ||
A Feather in an Oval Opening is a Fringe of material left behind where the cut started and ended on the Oval. If the Oval Opening has a Feather, Decrease the Oval Rotation. The Oval Rotation controls for Bumps or Feathers on an Oval. See: Oval Rotation Configurations See: Oval Rotation for Openings Configurations See: Oval Rotation for Drops Configurations See: Oval Rotation for the Outside Configurations |
Adjusting Configurations and Doing Test Cuts
Adjust the Rotation values accordingly until satisfied.
After a particular size has been satisfactorily adjusted, click the Locked checkbox for that size to no longer cut nor adjust it.
Contents:
| |