...
Cartridges Involved
...
This Configuration element involves the following Cartridges.
| Info |
|---|
Note: Not all cartridges are available for all CMC models. |
...
Exterior Overcut on Creases Definition
...
Adjusting the Exterior Overcut
| Tip |
|---|
|
| Expand | ||
|---|---|---|
| ||
The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut. The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration. If the Exterior Overcut is cut too Long, Decrease the Exterior Overcut. If the Exterior Overcut is cut too Short, Increase the Exterior Overcut. |
...
Current Crease Bevel Type
...
Select the Crease Cartridge Tab.
| Tip |
|---|
|
...
Crease Exterior Overcut Too Long
...
Problem:
The Exterior Overcut is applied Too Long.
Resolution:
If the Exterior Overcut is cut too Long, Decrease the Exterior Overcut.
| Expand | ||
|---|---|---|
| ||
The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut. The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration. If the Exterior Overcut is cut too Long, Decrease the Exterior Overcut. If the Exterior Overcut is cut too Short, Increase the Exterior Overcut. |
...
Crease Exterior Overcut Too Short
...
Problem:
The Exterior Overcut is applied Too Short.
Resolution:
If the Exterior Overcut is cut too Short, Increase the Exterior Overcut.
| Expand | ||
|---|---|---|
| ||
The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut. The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration. If the Exterior Overcut is cut too Long, Decrease the Exterior Overcut. If the Exterior Overcut is cut too Short, Increase the Exterior Overcut. |
...
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
Too Long | Too Short | ||||||||||||||||||||||||||||||||||||||||||||||||||
|
|
 
|