Content Comparison

Note: Not all cartridges are available for all CMC models.

• The Crease Cartridge creases the material to make folding it easier when making Boxes.

A Cartridge is the physical component that holds a Blade, Deboss Stylus, Pen or other application tool.

• Crease Cartridge

• The Crease Exterior Backup is Too Long.

• This is viewed from the front of the mat.

• If the Exterior Backup is cut too Long, Decrease the Exterior Backup.

• See Exterior Backup for additional information.

The Exterior Backup controls where the Blade Plunges into the Matboard (not the Fallout) on the Exterior cut. 

The Exterior Backup field is marked with a Green Arrow on the Configuration screen and the Map illustration.

If the Exterior Backup is cut too Short, it can leave a Hook in the corner.

If the Exterior Backup is cut too Long, Decrease the Exterior Backup.

If the Exterior Backup is cut too Short, Increase the Exterior Backup.

• The Crease Exterior Backup is Too Short.

• This is viewed from the front of the mat.

• If the Exterior Backup is cut too Short, Increase the Exterior Backup.

• See Exterior Backup for additional information.

The Exterior Backup controls where the Blade Plunges into the Matboard (not the Fallout) on the Exterior cut. 

The Exterior Backup field is marked with a Green Arrow on the Configuration screen and the Map illustration.

If the Exterior Backup is cut too Short, it can leave a Hook in the corner.

If the Exterior Backup is cut too Long, Decrease the Exterior Backup.

If the Exterior Backup is cut too Short, Increase the Exterior Backup.

• The Crease Exterior Overcut is applied Too Long.

• This is viewed from the front of the mat.

The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut.

The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

If the Exterior Overcut is cut too Long, Decrease the Exterior Overcut.

If the Exterior Overcut is cut too Short, Increase the Exterior Overcut.

• The Crease Exterior Overcut is applied Too Short.

• This is viewed from the front of the mat.

• If the Exterior Overcut is cut too Short, Increase the Exterior Overcut.

• See Exterior Overcut for additional information.

The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut.

The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

If the Exterior Overcut is cut too Long, Decrease the Exterior Overcut.

If the Exterior Overcut is cut too Short, Increase the Exterior Overcut.

• Crease is applied at the Wrong Size.

• This is viewed from the front of the mat.

• If the Opening is cut too Large, Decrease the Opening Adjustment.

• If the Opening is cut too Small, Increase the Opening Adjustment.

• See Opening Adjustment for additional information.

The Opening Adjustment controls the size of the Object cut or applied with non-blade cartridges.

If the Opening is cut too Large, Decrease the Opening Adjustment.

If the Opening is cut too Small, Increase the Opening Adjustment.

• Select this topic to see information on editing with the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview. 

The Troubleshooting Utility allows you to bring in a single opening and automatically selects the correct Cartridge tab and Bevel Type to configure.

• The Crease is applied at the Wrong Depth When Using a SKU.

• The Blade Depth is too Deep, Decrease the Depth Bias.

• The Blade Depth is too Shallow, Increase the Depth Bias.

• See Depth Bias for additional information.