Page Comparison

A Cartridge is the physical component that holds a Blade, Deboss Stylus, Pen or other application tool.

Take note that there is a separate configuration for cutting from the front (Normal Bevel - Front of Mat) and cutting from the back (Normal Bevel).

A Cartridge is the physical component that holds a Blade, Deboss Stylus, Pen or other application tool.

The Bevel Type is the Angle that the blade cuts on the Matboard/Fallout surface when it is not cut at a 90° Right Angle.

A Cartridge is the physical component that holds a Blade, Deboss Stylus, Pen or other application tool.

The Bevel Type is the Angle that the blade cuts on the Matboard/Fallout surface when it is not cut at a 90° Right Angle.

A Cartridge is the physical component that holds a Blade, Deboss Stylus, Pen or other application tool.

The Bevel Type is the Angle that the blade cuts on the Matboard/Fallout surface when it is not cut at a 90° Right Angle.

A Cartridge is the physical component that holds a Blade, Deboss Stylus, Pen or other application tool.

The Bevel Type is the Angle that the blade cuts on the Matboard/Fallout surface when it is not cut at a 90° Right Angle.

A Cartridge is the physical component that holds a Blade, Deboss Stylus, Pen or other application tool.

The Bevel Type is the Angle that the blade cuts on the Matboard/Fallout surface when it is not cut at a 90° Right Angle.

A Cartridge is the physical component that holds a Blade, Deboss Stylus, Pen or other application tool.

The Deboss cartridge stylus presses onto the surface of the matboard to create a subtle design.

There are three Deboss stylus sizes: Wide, Medium, Thin.

In addition to Templates, you can also Deboss CutArts, LetterMats and TTFs.

A Cartridge is the physical component that holds a Blade, Deboss Stylus, Pen or other application tool.

The Pen Cartridge is used to draw onto the surface of the matboard on the CMC to create a design.

In addition, you can also Pen Designs, CutArts, LetterMats and TTFs.

A Cartridge is the physical component that holds a Blade, Deboss Stylus, Pen or other application tool.

The Vinyl Cartridge uses a special blade to cut the Vinyl which has been temporarily adhered to matboard to create the design.

A Cartridge is the physical component that holds a Blade, Deboss Stylus, Pen or other application tool.

The Bevel Type is the Angle that the blade cuts on the Matboard/Fallout surface when it is not cut at a 90° Right Angle.

The Standard, Normal or Forward Bevel is when the Angle of the blade cuts the Matboard/Fallout surface so it slants away from the surface of the Matboard/Fallout, and the matboard core is seen from the front.

The Reverse Bevel is when the Angle of the blade cuts the Matboard/Fallout surface so it slants under the surface of the Matboard/Fallout, and the matboard core is not seen from the front.

The 90° Straight Bevel is the lack of Angle that the blade cuts on the Matboard/Fallout surface, as it cuts at a 90° Right Angle, and the matboard core is not seen from the front.