Cartridges Involved
This Configuration element involves the following Cartridges.
| Info |
|---|
Note: Not all cartridges are available for all CMC models. |
Crease Cartridge Configurations
| Info |
|---|
|
Crease Tab
Select the Deboss Tab on the Configurations screen.
Select the Crease Cartridge.
| Tip |
|---|
|
Crease Exterior Backup is too Long
Problem:
The Crease Exterior Backup is too Long.
Resolution:
If the Exterior Backup is cut too Long, Decrease the Exterior Backup.
See Exterior Backup for additional information.
| Expand | ||
|---|---|---|
| ||
The Exterior Backup controls where the Blade Plunges into the Matboard (not the Fallout) on the Exterior cut. |
Crease Exterior Backup is too Short
Problem:
The Crease Exterior Backup is too Short.
Resolution:
If the Exterior Backup is cut too Short, Increase the Exterior Backup.
See Exterior Backup for additional information.
| Expand | ||
|---|---|---|
| ||
The Exterior Backup controls where the Blade Plunges into the Matboard (not the Fallout) on the Exterior cut. |
Crease Exterior Overcut is too Long
Problem:
The Crease Exterior Overcut is applied Too Long.
Resolution:
If the Exterior Overcut is cut too Long, Decrease the Exterior Overcut.
| Expand | ||
|---|---|---|
| ||
The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut. |
Crease Exterior Overcut is too Short
Problem:
The Crease Exterior Overcut is applied Too Short.
Resolution:
If the Exterior Overcut is cut too Short, Increase the Exterior Overcut.
See Exterior Overcut for additional information.
| Expand | ||
|---|---|---|
| ||
The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut. |
Crease is the Wrong Size
Problem:
Crease is applied at the Wrong Size.
Resolution:
If the Opening is cut too Large, Decrease the Opening Adjustment.
If the Opening is cut too Small, Increase the Opening Adjustment.
See Opening Adjustment for additional information.
| Expand | ||
|---|---|---|
| ||
The Opening Adjustment controls the size of the object cut or applied with non-blade cartridges. |
Contents: |
Problem:
The Crease is applied at the Wrong Depth When Using a SKU.
Resolution:
The Blade Depth is too Deep, Decrease the Depth Bias.
The Blade Depth is too Shallow, Increase the Depth Bias.
See Depth Bias for additional information.
| title | Depth Bias Definition |
|---|
Set Box Defaults
| title | Default Settings for the Box Utility |
|---|
Set up the Box Defaults for the Crease cartridge in the Admin Editor section of the software.
| Info |
|---|
|
| Expand | ||
|---|---|---|
| ||
The Troubleshooting Utility allows you to bring in a single opening and automatically selects the correct Cartridge tab and Bevel Type to configure. |
|