Versions Compared

Version Old Version 2 New Version Current
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
The Overcut controls where the cartridgeRetracts from the Matboard.

  • If the Overcut is cut Too Long, Decrease the Overcut.

  • If the Overcut is cut Too Short, Increase the Overcut.

  • The Overcut field is marked with a Red Arrow on the Configuration screen and the Map/wiki/spaces/FrameShop8x/pages/1942503207illustration.

    • Image RemovedImage Removed

    See: Overcut for Creases Configurations

    Crease Overcut is Too Short

    • If the Overcut is Too Short, Increase the Overcut.

    Panel
    panelIconId1f9d9-200d-2642-fe0f
    panelIcon:man_mage:
    panelIconText🧙‍♂️
    bgColor#FFFAE6
    Expand
    titleExterior Overcut of Creases Definition
    Expand
    titleHow to Adjust the Exterior Overcut

    When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

    Click OK and do another test cut.

    Continue making adjustments until the desired outcome is achieved.

    Image RemovedImage Removed
    Insert excerpt
    Overcut Crease
    Overcut Crease
    nameOvercut Crease Definition
    Image AddedImage Added

    Insert excerpt
    How to Adjust the Configurations
    How to Adjust the Configurations
    nameHow to Adjust Configurations
    nopaneltrue