Select Shared Edge from the Outside Cut Options dropdown control to cut the shared edges of the outside cuts on the CMC Z1 and Z (9000z) as one stroke between the designs instead of | Panel |
|---|
| panelIconId | atlassian-plus |
|---|
| panelIcon | :plus: |
|---|
| panelIconText | :plus: |
|---|
| bgColor | #FFFAE6 |
|---|
| |
|
If cutting a single design, it will cut only the top and right edges of the outside cut, using the factory edge of the mat for the left and bottom, thus not wasting any matboard since the Z1 and Z (9000z) can cut right to the edges.
If cutting a tiled mat, this will cut the outside shared lines between designs as one cut cut, rather than cutting each design's outside edge individually.
Image RemovedThis feature is only for the CMC Z1, Z(9000z), 9000 and 8000+. Make sure that the Spacing between the outsides is set to Zero (0).
|
|  Image Added |