Cartridges Involved
This Configuration element involves the following Cartridges.
| Info |
|---|
Note: Not all cartridges are available for all CMC models. |
Crease Cartridge Configurations
The Crease Cartridge creases the material to make folding it easier when making Boxes.
Crease Tab
| Info |
|---|
|
Crease Exterior Backup is too Long
Problem:
The Crease Exterior Backup is too Long.
Resolution:
Decrease the Exterior Backup.
See Exterior Backup for additional information.
| Info |
|---|
|
Crease Exterior Backup is too Short
Problem:
The Crease Exterior Backup is too Short.
Resolution:
Increase the Exterior Backup.
See Exterior Backup for additional information.
| Info |
|---|
|
Crease Exterior Overcut is too Long
Problem:
The Crease Exterior Overcut is applied too Long.
Resolution:
Decrease the Exterior Overcut.
| Info |
|---|
|
Crease Exterior Overcut is too Short
Problem:
The Crease Exterior Overcut is applied too Short.
Resolution:
Increase the Exterior Overcut.
See Exterior Overcut for additional information.
| Info |
|---|
|
Crease is the Wrong Size
Problem:
Crease is applied at the Wrong Size.
Resolution:
If cut too small, increase the Opening Adjustment.
If cut too large, decrease the Opening Adjustment.
See Opening Adjustment for additional information.
| Info |
|---|
|
Contents: |
Troubleshooting Button
| Info |
|---|
|
Set Box Defaults
| Info |
|---|
|
The Crease is applied at the Wrong Depth When Using a SKU.
Resolution:
Cut too shallow, increase the Depth Bias.
Cut too deep, decrease the Depth Bias.
See Depth Bias for additional information.
|