Remnant Trimming |
|---|
Select the desired remnant trimming direction on the CMC Z1 and Z (9000z) from the Remnant Trimming dropdown control. This will trim off the remaining section of the matboard to make it easier to store the remaining pieces for future use. |
...
Remnant Trimming: Vertical | |
|---|---|
Set Remnant Trimming to Vertical to set the default to cut the remnant matboard off vertically. | |
Click the Set Advanced Options button on the Cut Preview to access the Advanced Outside Options. Set Remnant Trimming to Vertical. |  |
The design will cut and trim off the remnant matboard vertically. |  |
Set the Default for Cutting the Outside | |
|---|---|
The default setting for Cutting the Outside can be set in the Admin > Editor section. |  |
Set the Default for 90 Degree Outside Cut | |
|---|---|
The default setting for 90 Degree Outside can be set in the Admin > Cutting section. |  |
Set the Default for the Advanced Options | |
|---|---|
The default setting for the Advanced Options can be set in the Admin > Cutting section. |  |
Set the Default for Remnant Trimming | |
|---|---|
The default setting for the Remnant Trimming can be set in the Admin > Cutting section. |  |