Versions Compared

Old Version 17

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version Current

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

  • For Additional Information:

    • Click the Visualizebutton on the Main Screen to open Visualize.

  • Click the Take Picture button on the Main Screen to take a photo to open Visualize.

  • Click the Load File Image button on the Main Screen to load an image to open Visualize.

  • Click the Visualize button in the Design Editor.

    • Tip

    • Default Settings:

    • See Admin > Defaults for the default settings for Loading Images.

    • See Admin > Editor for the default settings for the Camera Defaults.

    • See Admin > Editor for the default settings for the Wink Camera Defaults.

    Check Software Measurements

    Info

    • Check the software measurements to make sure that images taken with the camera are displayed at the correct scale, so that art, mats and frame moulding will display proportionally correct.

    • Open the FrameShop software and click on Visualize.

    Panel
    panelIconId1f9d9-200d-2642-fe0f
    panelIcon:man_mage:
    panelIconText🧙‍♂️
    bgColor#FFFAE6
    Image Modified

    • Place a measuring tape on the design table. 

    • Click the Take Picture button on the Images tab.

    		Image Modified

    • If there is more than one device available, select the desired camera from the dropdown control on the Camera Capture Screen.

    		Image Modified
    		Image Modified

    • A photo of the measuring tape is displayed.

    		Image Modified

    • Click the Set New Scale button.

    • Draw a box Horizontally along the Ruler; take as long of a measurement as possible as this improves the software's measurements.

    		Image Modified

    • A screen opens requesting the Width Measurement.

    • Enter the specific width that was measured within this box.

    • Click OK. 

    Info

    • The Scale for the camera is now set.

    		Image Modified

    Measure a Piece of Art

    Info

    • Measure a piece of Art taken with the Camera to make sure that the Scale is set correctly, so that Art and Moulding will display proportionally correct.

    • Click the Take Picturebutton.

    • Position a piece of Art under the camera and center it in the field of view.

    • Click Take Picture.

    • Click on the Art Regions Tab.

    • Click Add New Art Region button.

    • Draw a selection box around the Art.

    • The dimensions of the image displays on the Selected Region width and height boxes.             

    • The dimensions of the image should be correct, within approximately 1/8 inches. If the dimensions are correct and the image still appears “square,” then the camera is Calibrated at this specific Fixed Zoom Point.

    		Image Modified

    Calibration Complete 

    Info

    • The Camera is now Calibrated and will remain calibrated as long as the camera is not physically moved.

    • If the Camera or Camera Mount is moved, the entire procedure must be repeated.

    • When saving a project to the database or to a file, the Scale Setting is saved with the project.

    • Thus, if using different zoom points and recalling a project from storage may require the Scale to be set again for the next new project started.

    • For Fixed Zoom, the software only remembers One Scale Value and that value will be changed when loading a prior project from storage.

    Default Settings