Versions Compared

Old Version 15

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version Current

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Panel
panelIconIdatlassian-plus
panelIcon:plus:
panelIconText:plus:
bgColor#FFFAE6

  • The Line tool in Trace will draw a Two-Point Line in Trace. The Line is defined by two points:

    • Initial Position (

    called an

    • Anchor)

    and the

    • Terminating Position (

    called an

    • Anchor)

    .After it is drawn, a third point in the Center will be displayed, which can be moved to alter the line into an Arc.

  • When drawing:

    • Left-Click sets the Point under the Cursor.

    • Right-Click Snapsto the nearest Point.

    • Hold down the CTRL key to draw in Ortho Mode; i.e., Horizontally/Vertically only.

  • After it is drawn, a Center point will be displayed, which can be moved to alter the line into an Arc.

Excerpt
hiddentrue
nameLine Tool Definition

  • The Line tool in Trace will draw a Two-Point Line in Trace. 

  • The Line is defined by two points: Initial Position (called an Anchor) and the Terminating Position (called an Anchor).

  • After it is drawn, a third point in the Center will be displayed, which can be moved to alter the line into an Arc.

    • Left-Click sets the Point under the Cursor.

    • Right-Click Snapsto the nearest Point.Hold down the CTRL key to draw in Ortho Mode; i.e., Horizontally/Vertically only.Full Definition: Line Tool Definition