Cartridges Involved
This Configuration element involves the following Cartridges.
Note: Not all cartridges are available for all CMC models.
Crease Cartridge Configurations
The Crease Cartridge creases the material to make folding it easier when making Boxes.
Crease Tab
Below is a list of support documentation for editing the configurations of the Crease Cartridge on the Crease Tab.
Crease Exterior Backup is too Long
Problem:
The Crease Exterior Backup is too Long.
Resolution:
Adjust the Crease Exterior Backup. Select this topic to see information on editing the Exterior Backup.
| Info |
|---|
|
Crease Exterior Backup is too Short
Problem:
The Crease Exterior Backup is too Short.
Resolution:
Adjust the Crease Exterior Backup. Select this topic to see information on editing the Crease Exterior Backup.
| Info |
|---|
|
Crease Exterior Overcut is too Long
Problem:
The Crease Exterior Overcut is applied too Long.
Resolution:
Adjust the Crease Exterior Overcut. Select this topic to see information on editing the Crease Exterior Overcut.
| Info |
|---|
|
Crease Exterior Overcut is too Short
Problem:
The Crease Exterior Overcut is applied too Short.
Resolution:
Adjust the Crease Exterior Overcut. Select this topic to see information on editing the Crease Exterior Overcut.
| Info |
|---|
|
Crease is the Wrong Size
Problem:
Crease is applied at the Wrong Size.
Resolution:
Adjust the Crease Opening Adjustment. Select this topic to see information on editing the Opening Adjustment.
| Info |
|---|
|
Contents: |
Problem:
The Crease is applied at the Wrong Depth When Using a SKU.
Resolution:
Adjust the Crease Depth Bias. Select this topic to see information on editing the Depth Bias.
Troubleshooting Button
| Info |
|---|
|
Set Box Defaults
Set up the Box Defaults for the Crease cartridge in the Admin Editor section of the software.
|