Content Comparison

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Image Removed

Crease Cartridge Configurations

The Crease Cartridge creases the material to make folding it easier when making Boxes.

Image Removed

Crease Tab

Below is a list of support documentation for editing the configurations of the Crease Cartridge on the Crease Tab.

Image Removed

Crease Exterior Backup is too Long

Problem:

• The Crease Exterior Backup is applied too Long.

Resolution:

• Adjust the Crease Exterior Backup. Select this topic to see information on editing the Exterior Backup.

• This is viewed from the front of the mat.

Image Removed

Crease Exterior Backup is too Short

Problem:

• The Crease Exterior Backup is applied too Short.

Resolution:

• Adjust the Crease Exterior Backup. Select this topic to see information on editing the Crease Exterior Backup.

• This is viewed from the front of the mat.

Image Removed

Crease Exterior Overcut is too Long

Problem:

• The Crease Exterior Overcut is applied too Long.

Resolution:

• Adjust the Crease Exterior Overcut. Select this topic to see information on editing the Crease Exterior Overcut.

• This is viewed from the front of the mat.

Image Removed

Crease Exterior Overcut is too Short

Problem:

• The Crease Exterior Overcut is applied too Short.

Resolution:

• Adjust the Crease Exterior Overcut. Select this topic to see information on editing the Crease Exterior Overcut.

• This is viewed from the front of the mat.

Image Removed

Crease is the Wrong Size

Problem:

• Crease is applied at the Wrong Size.

Resolution:

• Adjust the Crease Opening Adjustment. Select this topic to see information on editing the Opening Adjustment.

• This is viewed from the front of the mat.

Image Removed

Problem:

• The Crease is applied at the Wrong Depth When Using a SKU.

Resolution:

• Adjust the Crease Depth Bias. Select this topic to see information on editing the Depth Bias.

Image Removed

Troubleshooting Button 

• Select this topic to see information on editing with the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview. 

Image Removed

Set Box Defaults

• Set up the Box Defaults for the Crease cartridge in the Admin Editor section of the software.

Image Removed