Remnant Trimming |
|---|
Select the desired remnant trimming direction on the CMC Z1 and Z (9000z) from the Remnant Trimming dropdown control. This will trim off the remaining section of the matboard to make it easier to store the remaining pieces for future use. |
Set Advanced Options: Remnant Trimming | |
|---|---|
Click the Set Advanced Options button on the Cut Preview to access the Advanced Outside Options. |   |
Make the desired selection for the Remnant Trimming as described below. Click OK. The CMC will cut with these settings. |   |
Remnant Trimming: Off | |
|---|---|
Set Remnant Trimming to Off to not cut off the remnant from the sheet of matboard. | |
Click Click the Set Advanced Options to button on the Cut Previewto access the Advanced Outside Cut Advanced Outside Options. Set Remnant Trimming to Off. |   |
The design will cut but not trim off the remnant that remains from the matboard. |   |
Remnant Trimming: Auto | |
|---|---|
Set Remnant Trimming to Auto to let the software determine the best direction to cut off the remnant. | |
Click Click the Set Advanced Options to button on the Cut Preview to access the Advanced Outside Cut Advanced Outside Options. Set Remnant Trimming to Auto to let the software determine the best direction to cut off the remnant. |   |
The software will automatically determine the best direction to cut off the remnant matboard by selecting either vertically or horizontally depending upon the design. |   |
Remnant Trimming: Horizontal | |
|---|---|
Set Remnant Trimming to Horizontal to default to cut the remnant off horizontally. | |
Click Click the Set Advanced Options to button on the Cut Preview to access the Advanced Outside Cut Advanced Outside Options. Set Remnant Trimming to Horizontal. |   |
The design will cut and trim off the remnant matboard horizontally. |   |
Remnant Trimming: Vertical | |
|---|---|
Set Remnant Trimming to Vertical to set the default to cut the remnant matboard off vertically. | |
Click Click the Set Advanced Options to button on the Cut Preview to access the Advanced Outside Cut Advanced Outside Options. Set Remnant Trimming to Vertical. |   |
The design will cut and trim off the remnant matboard vertically. |   |
Set the Default for Cutting the Outside | |
|---|---|
The default setting for Cutting the Outside Outside can be set in the Admin > Editor section. |   |
Set the Default for 90 Degree Outside Cut | |
|---|---|
The default setting for 90 Degree Outside Outside can be set in the Admin > Cutting section. |   |
Set the Default for the Advanced Options | |
|---|---|
The default setting for the Advanced Options Options can be set in the Admin > Cutting section. |   |
Set the Default for Remnant Trimming | |
|---|---|
The default setting for the Remnant Trimming Trimming can be set in the Admin > Cutting section. |   |