Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Align the Head Button on the 9000/8000/8000RC/8000

RC

+

  • Click the Align the Head button to Align the Head into the cutting position and power up the motors in preparation of cutting a mat.

Panel
panelIconId1f9d9-200d-2642-fe0f
panelIcon:man_mage:
panelIconText🧙‍♂️
bgColor#FFFAE6
Info
  • Aligning the Head will

only
  • get the machine ready to cut, but not actually cut.

  • You will need to click the Cut Button to cut the design.

Info
  • NOTE: The hardware photos below may slightly differ from your specific model but the steps are still the same.

Image Removed
Image Added

Align the Head Button vs. the Cut Button

  • Optionally, if you click the Cut button when the motors are disengaged, it will prompt you to Align the Head.

  • After the Head is Aligned, itwill then Cut the mat.

Image Removed

CutScreenCutAlignHeadMiniZ1-70800.pngImage Added

Aligning the Head on the CMC 9000/8000/8000 RC/8000+ When Motors are Disengaged

  • Rotate the

foot block
  • Footblock into the 12 O’Clock position. 

Image Modified
  • Holding it about an inch above the bottom rail, slide the

gantry
  • Gantry and the

head
  • Head assembly to the left edge of the CMC until it stops. 

Image Modified
  • It will stop against the Magnetic Stop.

Image Modified
  • Then slide the

head
  • Head down until the

foot block
  • Footblock rests against the

head alignment stop
  • Head Alignment Stop.

Image Modified
  • Click the Align the Head button or click the Cut button to finish the Align the Head sequence.

Image Removed
Image Added
  • Click Continue on the Align the Head screen.

Image Removed
Image Added
  • Head will align to the

home
  • Home position.

Image Modified
  • If you clicked the Align the Head button, the CMC is now aligned and ready to cut.

  • If you clicked the Cut button, the CMC will now begin to cut the mat.

Image Removed

See Also: Disengage Button

Use the Disengage button to cut the power to the motors of the cutting head.

  • Click the Disengage button to disengage power to the motors of the cutting Head on the CMC. 

  • User will be prompted to Click OK to release the motors.

  • Grasp the Head and then Click OK

  • The motors will be disengaged and the Head will drop. When the motors are disengaged, the Head and the Gantry can be moved freely by hand.

  • The head will need to be Aligned again before the next mat is cut.

Image RemovedClick the Reset Motors Head Button to Disengage Power to the Motors
Image Added