Line Design Details | |
|---|---|
| |
|
The Line tool in Trace will draw a Two-Point Line.
The Line is defined by two points: the Initial Position and the Terminating Position (which are called “anchors”).
After it is drawn, a third point in the Center is displayed, which can be moved to alter the Line into an Arc.
|  | ||||
|
 |
Design Line Details | |
|---|---|
Start X and Start Y | |
|
|
|
| Expand | ||
|---|---|---|
| ||
The Y Position field is used to set or display the Vertical position of the selected object in Designer, Trace and the Cut Preview. |
|  | ||||
Mid X and Mid Y
|
| Expand | ||
|---|---|---|
| ||
The X Position field is used to set or display the Horizontal position of the selected object in Designer, Trace and the Cut Preview. |
| Expand | ||
|---|---|---|
| ||
The Y Position field is used to set or display the Vertical position of the selected object in Designer, Trace and the Cut Preview. |
 | ||
End X and End Y
|
| Expand | ||
|---|---|---|
| ||
The X Position field is used to set or display the Horizontal position of the selected object in Designer, Trace and the Cut Preview. |
| Expand | ||
|---|---|---|
| ||
The Y Position field is used to set or display the Vertical position of the selected object in Designer, Trace and the Cut Preview. |
 |
Angle |
|
 |
Length |
|
 |
Bevel Type |
|
|
|
The Bevel Type is the Angle that the blade cuts on the Matboard/Fallout surface when it is not cut at a 90° Right Angle.
| Expand | ||
|---|---|---|
| ||
Tracing the Design provides the Bevel Type and other necessary information to the Vector design in order to either Cut or apply a Non-Blade Tool on the CMC. The Set Bevels Tab in Trace contains the tools needed to Trace the design. |
|  | ||||
Layer |
|
 |
| title | Traced Definition |
|---|
Tracing the Design provides the Bevel Type and other necessary information to the Vector design in order to either Cut or apply a Non-Blade Tool on the CMC.
The Set Bevels Tab in Trace contains the tools needed to Trace the design.
Related Links |
|---|