Versions Compared

Old Version 1

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version Current

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Calculate Opening Adjustments

  1. Cut a one layer rectangle opening. 

  2. From the front of the mat, measure the Width and Height of the opening from the inside of the bevel. 

  3. Enter those values into the Actual Height and Actual Width fields. 

  4. Click on the Calc Opening Adjustment button to recalculate and adjust the Opening Adjustment value. 

  5. Do a test cut to confirm that it is correct and readjust if necessary.

Panel
panelIconId1f9d9-200d-2642-fe0f
panelIcon:man_mage:
panelIconText🧙‍♂️
bgColor#FFFAE6

  • For Additional Information:

  • See Opening Adjustment for information on adjusting the object’s size.

Expand
titleOpening Adjustment General Definition

The Opening Adjustment controls the size of the Opening cut or Object applied with non-blade cartridges.

If the Opening is cut Too Large, Decrease the Opening Adjustment.

If the Opening is cut Too Small, Increase the Opening Adjustment.

See: Opening Adjustment for Openings Configurations

See: Opening Adjustment for Drops Configurations

See: Opening Adjustment for Outsides Configurations

See: Opening Adjustment for V-Grooves Configurations

See: Opening Adjustment for Deboss Configurations

See: Opening Adjustment for Pens Configurations

See: Opening Adjustment for Vinyls Configurations

See: Opening Adjustment for Creases Configurations