Page Comparison

Horizontal Home for Openings
The Horizontal Home defines the global horizontal placement of objects cut with the blade cartridges.	Image RemovedImage Added

Opening Cuts too Far to the Right when Not Cutting the Outside: Horizontal Border too Big
Adjust the Horizontal Home if the opening is cutting too far to the right (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat.
The opening is cutting too far to the right.	Image RemovedImage Added
Decrease the Horizontal Home.	Image RemovedImage Added
The opening will now cut in the correct place.	Image RemovedImage Added

Opening Cuts too Far to the Left when Not Cutting the Outside: Horizontal Border too Small
Adjust the Horizontal Home if the opening is cutting too far to the left (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat.
The opening is cutting too far to the left.	Image RemovedImage Added
Increase the Horizontal Home.	Image RemovedImage Added
The opening will now cut in the correct place.	Image RemovedImage Added

Horizontal Home Troubleshooting
Alternatively, adjust the Horizontal Home on the Troubleshooting Screen.

Adjusting the Horizontal Position for Non-Blade Cartridges
To adjust the Horizontal placement of the non-blade cartridges, (i.e., Deboss, PenorVinyl tools), see Horizontal Adjustment.	Image RemovedImage Added

Versions Compared