...
Opening Cuts too Far to the Right when Not Cutting the Outside: Horizontal Border too Big | |
|---|---|
Adjust the Horizontal Home if the opening is cutting too far to the right (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat. | |
The opening is cutting too far to the right. |   |
Decrease the Horizontal Home. |   |
The opening will now cut in the correct place. |   |
Opening Cuts too Far to the Left when Not Cutting the Outside: Horizontal Border too Small | |
|---|---|
Adjust the Horizontal Home if the opening is cutting too far to the left (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat. | |
The opening is cutting too far to the left. |   |
Increase the Horizontal Home. |   |
The opening will now cut in the correct place. | |
Horizontal Home Troubleshooting | |
|---|---|
Alternatively, adjust the Horizontal Home on the Troubleshooting Screen. |  |
Adjusting the Horizontal Position for Non-Blade Cartridges | |
|---|---|
To adjust the Horizontal placement of the non-blade cartridges, (i.e., Deboss, PenorVinyl tools), see Horizontal Adjustment. |  |