Versions Compared

Version Old Version 2 New Version 3
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Crease Overcut is Too Short

  • If the Overcut is Too Short, Increase the Overcut.

Insert excerpt
Overcut Crease
Overcut Crease
nameOvercut Crease Definition
nopaneltrue

Panel
panelIconId1f9d9-200d-2642-fe0f
panelIcon:man_mage:
panelIconText🧙‍♂️
bgColor#FFFAE6
Expand
titleExterior Overcut of Creases Definition
The Overcut controls where the cartridgeRetracts from the Matboard.

  • If the Overcut is cut Too Long, Decrease the Overcut.

  • If the Overcut is cut Too Short, Increase the Overcut.

  • The Overcut field is marked with a Red Arrow on the Configuration screen and the Map/wiki/spaces/FrameShop8x/pages/1942503207illustration.

    • Image RemovedImage RemovedSee: Overcut for Creases Configurations

    Expand
    titleHow to Adjust the Exterior Overcut

    When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

    Click OK and do another test cut.

    Continue making adjustments until the desired outcome is achieved.