changes.mady.by.user dani.simmonds
Saved on Sept 18, 2024
Saved on Oct 02, 2024
Check the software measurements to make sure that images taken with the camera are displayed at the correct scale, so that art, mats and frame moulding will display proportionally correct.
Open the FrameShop software and click on Visualize.
For Additional Information:
Click the Take Picture button on the Main Screen to take a photo to open Visualize.
Click the Load File Image button on the Main Screen to load an image to open Visualize.
Click the Visualize button in the Design Editor.
Default Settings:
See Admin > Defaults for the default settings for Loading Images.
See Admin > Editor for the default settings for the Camera Defaults.
See Admin > Editor for the default settings for the Wink Camera Defaults.Default Settings:
Wizard Wink Camera: Editor Default Setting
Camera Defaults: Editor Default Settings
Camera Timeout: Editor Default Setting
Camera Retries: Editor Default Setting
Camera Init Timeout: Editor Default Setting
Place a measuring tape on the design table.
Click the Take Picture button on the Images tab.
If there is more than one device available, select the desired camera from the dropdown control on the Camera Capture Screen.
Click the Take Picture button.
A photo of the measuring tape is displayed.
Click the Set New Scale button.
Draw a box Horizontally along the Ruler; take as long of a measurement as possible as this improves the software's measurements.
A screen opens requesting the Width Measurement.
Enter the specific width that was measured within this box.
Click OK.
The Scale for the camera is now set.
...
