Page Comparison

• The Circuit List will display a List of the Circuits located on the design along with details about them.

  • Circuits are enclosed objects.

• The Layer column displays what Layer the object is located on if it is Traced.

  • If it is not traced, the circuits reside on layer 1.

• The Start column displays the Start X/Y Coordinates of the object's start point when drawn.

• If you clicked on the upper left and drew by dragging to the lower right, that would make the start point on the upper left corner. 

• The Size column displays the size of each object.

A Circuit is an enclosed, connected object such as a Rectangle or a Polygon in Trace.

Tracing the Design provides the Bevel Type and other necessary information to the Vector design in order to either Cut or apply with a Non-Blade Tool on the CMC.

The Set Bevels Tab in Trace contains the tools needed to Trace the design.

See: Tracing the Design

The X Position field is used to set or display the Horizontal position of the selected object in Designerthe Design Editor, Trace and the Cut Preview. 

The Y Position field is used to set or display the Vertical position of the selected object in Designerthe Design Editor, Trace and the Cut Preview.