Page Comparison

• For Additional Information: See Troubleshooting Utility for information on adjusting the object’s size.

The Opening Adjustment controls the size of the Opening cut or Object applied with non-blade cartridges.

If the V-Groove is cut Too Large, Decrease the Opening Adjustment.

Image Removed

Image Removed

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• For Additional Information: See Troubleshooting Utility for information on adjusting the object’s size.

The Opening Adjustment controls the size of the Opening cut or Object applied with non-blade cartridges.

If the V-Groove is cut Too Small, Increase the Opening Adjustment.

Image Removed

Image Removed

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• For Additional Information: See Width Adjustment for information on adjusting the Width of the V-Groove.

The Width Adjustment controls the Width of the V-Groove Lines.

If the V-Groove is cutting Too Thin, Increase the Width Adjustment.

If the V-Groove is cutting Too Wide, Decrease the Width Adjustment.

Image Removed

See: Width Adjustment

• First Cut: Cuts the Interior cut into the Fallout Clockwise.

• Second Cut: Cuts the Exterior cut into the Matboard Counter-Clockwise.

• Enter the measured height and width of the opening into the appropriate fields and clicking the Calc Opening Adjustment button. 

• Make sure that only a single opening is present on the screen, otherwise the Troubleshooting Button will be grayed out.