Page Comparison

• For Additional Information:

• See Depth Bias for information on setting the Depth Bias.

• See Matboard Properties for information on assigning matboard SKUs to each layer of the design in Designer.

• See Mat SKUs for information on assigning matboard SKUs to each layer of the design in Visualize.

• See Frame SKUs for information on assigning Frame SKUs to each layer of the design in Visualize.

• See Assign SKU to Layer for more information on Assigning a SKU to a Layer on the Cut Preview.

• Default Settings:

• See Admin > Subscription for the default settings for Subscribing to Vendors.

• See Admin > Frames for the default settings for Frame Records for Vendors you are Subscribed to.

• See Admin > Mats for the default settings for Mat Records for Vendors you are Subscribed to.

The Depth Bias is used to calculate the properBlade Depth when the SKUselected for the matboard contains the Matboard Thickness.

If the Blade Depth is cut Too Deep, Decrease the Depth Bias.

If the Blade Depth is cut Too Shallow, Increase the Depth Bias.

The formula is: [(Default Depth) - 10]

For example, if the normal Blade Depth for 4-ply is 11, then 11-10=1, so enter 1 for the Depth Bias.

See: Depth Bias

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• For Additional Information:

• See Rotation for adjusting for a Swoop or Flare in a Non-Oval.

• See Troubleshooting Utility for information on adjusting for a Swoop or Flare in a Non-Oval.

A Swoop in an Opening is where the corners Curve Inward toward the opening.

If the Opening has a Swoop, Increase the Rotation.

The Rotation controls for Swoops and Flares in Openings.

See: Rotation Configurations

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• For Additional Information: 

• See Troubleshooting Utility.

• See Oval Rotation for adjusting for a Feather or a Bump in an Oval.

• See Circle/Oval Rotation Utility to adjust for a Feather or Bump in an Oval.

• See Rotation for adjusting for a Swoop or Flare in a Non-Oval.

• See Horizontal Home which defines the global Horizontal placement of objects cut with the Blade Cartridges.

• See Vertical Home which defines the global Vertical placement of objects cut with the Blade Cartridges.

• See Opening Adjustment for information on adjusting the object’s size.

The Troubleshooting Utility allows you to bring in a single opening and automatically selects the correct Cartridge tab and Bevel Type to configure.