Page Comparison

• Select the desired Remnant Trimming direction on the CMC Z1, Z (9000z), 9000 and 8000+ from the Remnant Trimming dropdown control. This will trim off the remaining section of the matboard to make it easier to store the remaining pieces for future use.   

• For Additional Information:

• See Matboard Properties in the Design to turn on/off the Outside cut.

• Select Options Menu > Cut Outside on the Cut Previewto cut the outside of the mat.

• See /wiki/spaces/FrameShop8x/pages/1942506497 on the Cut Previewto turn on/off the Outside cut.

• See Enable Outside Cutunder Advanced Outside Options on the Cut Previewto toggle on/off the Outside cut.

• See Cut Outside Using 90 Degree Tool under Set Advanced Optionson the Cut Preview.

• See Cut Mode in the Set Advanced Options section on the Cut Preview.

• See Shared Edge for the Cut Mode in the Set Advanced Options section on the Cut Preview.

• See Full for the Cut Mode in the Set Advanced Options section on the Cut Preview.

• See As Designed for the Cut Mode in the Set Advanced Options section on the Cut Preview.

• Default Settings:

• See Admin > Editor for the default settings for Cutting the Outside.

• See Admin > Cutting for the default settings for the Advanced Options.

• See Admin > Cutting for the default settings for the Cut Mode.

• See Admin > Cutting for the default settings for 90 Degree Outside.

• See Admin > Cutting for the default settings for Tiling.

• See Admin > Cutting for the default size for the Spacing between designs.

• See Admin > Cutting for the default settings for Remnant Trimming.

Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.

See: Remnant Trimming Function

Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.

See: Remnant Trimming Function