Page Comparison

These drawn designs can be quite intricate.

There is no need to worry about bevels being too close together, curves being too tight, or angles being too sharp because the matboard is not being cut. 

The Pen Cartridge is the part that holds the Pen Holder and attaches to the Head.

Select this topic to see information on Defining the Pen Tool in the Defaults.

Select this topic to see information on Install Pen: Set the Pen Tool Cartridge Depth Setting on the CMC Z1.

Select this topic to see information on Install Pen: Set the Pen Tool Cartridge Depth Setting on the CMC Z(9000z) and 9000.

Select this topic to see information on Selecting the Pen Cartridge in the Software: Designing Pen Elements.

Select this topic to see information on the Air Pressure for Drawing with the Pen Tool Cartridge to cut typical matboard or dense matboard material.

Select this topic to see information on Changing the Pen in the Pen Tool Cartridge.

Select this topic to see information on Changing to the Pen Tool Cartridge.

Select this topic to see information on Editing Pen Tool Cartridge Configurations.