Blade Depth ButtonUse the Blade Depth screen to select the Blade Depth for the current layer. | |
|---|---|
Blade Depth Click the Blade Depth Button to open the Blade Depth screen which allows the user to set the software blade depth for the current design. |  |
Blade Depth Field | |
|---|---|
Optionally, enter the desired Blade Depth in the Blade Depth field. |  |
| Click the |
Blade Depth | Quick Select button which is the mat corner sample at the top of the screen on the Cut Preview Screen | . | Blade Depth ScreenUse the Blade Depth screen to select the Blade Depth for the current layer. | |||||
|---|---|---|---|---|---|---|---|---|
Each time the Blade Depth Knob on the CMC is changed, the Blade Depth setting in the software must be changed to match. Using the correct Blade Depth in the software helps adjust the Backups and Overcuts and other Configuration adjustments to coincide with the Depth selected. |  | |||||||
...
Set As Default | |
|---|---|
Click the Set As Default button to set the current Blade Depth value as the Default Blade Depth for the associated Opening or V-Groove field. |  |
Set the Default for the Blade Depth | |
|---|---|
The default setting for the Blade Depth can be set in the Admin > Cutting section. This also sets the values for the preset Blade Depth Quick Select Entries. |  |
Blade Depth Field | |
|---|---|
Optionally, enter the desired Blade Depth in the Blade Depth field. | |
Blade Depth Quick SelectOptionally, use the Blade Depth Quick Select dropdown control to select one of the preset Blade Depths for the current design. | |
|---|---|
Click the Blade Depth Quick Select button which is the mat corner sample at the top of the screen on the Cut Preview Screen. Select the desired preset Blade Depth for the current layer from the dropdown control. The selected Blade Depth will be applied to the current layer. | |
Cartridge and Blade Depth Prompt for CMC Z1 | |
|---|---|
After selecting the desired Blade Depth for the current layer and Aligning the Head if necessary, Click Cut to cut the mat. If the current layer uses a different Cartridge or Blade Depth than the last mat cut, the user will be prompted to change the Cartridge and/or the Blade Depth. |  |
Replace the current Cartridge with the one requested on the Cartridge and Blade Depth Prompt. |  |
You can change the Blade Depth Value on the screen by clicking on the -/+ buttons to decrease/increase the Blade Depth Value. The Z1 will automatically adjust the physical Blade Depth of the CMC to this number when you click Continue. Click Continue to cut. |  |
...