Page Comparison

*See Determining the Degree of Rotation for information on how to determine the optimum degree of rotation for your particular CutArt.

The Rotation function in Designer is the action of rotating the selected object(s) around an axis or center by the specified number of degrees.

The Rotation function in Designer is the action of rotating the selected object(s) around an axis or center by the specified number of degrees.

CutArt™ are simple shapes and design elements created by Wizard.

CutArts can be applied to your current design and resized and rotated. They can be Cut, Debossed, Penned or cut on Vinyl.

• Save the CutArt. You will get a message stating that this design contains objects that do not have an assigned Bevel Type. This refers to the Alignment Lines that we didn't Trace. Click Yes that you wish to continue. 

• The CutArt is saved.

• Load the CutArt into the Design editor.

• Cut the CutArt.

• Since it is a Deboss design, you can also size it much smaller if desired without worrying about Overcuts and Backups

• Optionally, you can also bring the CutArt straight to the Cut Preview from Trace.

• The Starburst design is completed.

The Bevel Type is the Angle that the blade cuts on the Matboard/Fallout surface when it is not cut at a 90° Right Angle.

Tracing the Design provides the Bevel Type and other necessary information to the Vector design in order to either Cut or apply a Non-Blade Tool on the CMC.

The Set Bevels Tab in Trace contains the tools needed to Trace the design.

CutArt™ are simple shapes and design elements created by Wizard.

CutArts can be applied to your current design and resized and rotated. They can be Cut, Debossed, Penned or cut on Vinyl.

The Deboss cartridge stylus presses onto the surface of the matboard to create a subtle design.

There are three Deboss stylus sizes: Wide, Medium, Thin.

In addition to Templates, you can also Deboss CutArts, LetterMats and TTFs.