Page Comparison

The Horizontal home defines the global horizontal placement of objects cut with the blade cartridges.  

Adjust the Horizontal home if the opening is cutting too far to the right (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat.

This is viewed as it cut on the machine, i.e., from the back if cutting from the back, or from the front if cutting from the front.

The opening is cutting too far to the right.

Decrease the Horizontal home.

When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Adjust the Horizontal home if the opening is cutting too far to the left (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat.

This is viewed as it cut on the machine, i.e., from the back if cutting from the back, or from the front if cutting from the front.

The opening is cutting too far to the left.

Increase the Horizontal home.

When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Alternatively, adjust the Horizontal home on the Troubleshooting Screen.

To adjust the Horizontal placement of the non-blade cartridges, (i.e., Deboss, PenorVinyl tools), see Horizontal Adjustment.