...
Opening Cuts too Far to the Left when Not Cutting the Outside: Horizontal Border too Small | |
|---|---|
Adjust the Horizontal home if the opening is cutting too far to the left (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat. | |
This is viewed as it cut on the machine, i.e., from the back if cutting from the back, or from the front if cutting from the front. The opening is cutting too far to the left. |  |
Increase the Horizontal home. When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |   |
The opening will move to the right. |   |
Horizontal Home Troubleshooting | |
|---|---|
Alternatively, adjust the Horizontal home on the Troubleshooting Screen. |   |
Adjusting the Horizontal Position for Non-Blade Cartridges | |
|---|---|
To adjust the Horizontal placement of the non-blade cartridges, (i.e., Deboss, PenorVinyl tools), see Horizontal Adjustment. |   |