Page Comparison

If you want to add a V-Groove, Deboss or Pen object and have it follow closely around a multi-layer template shape, the results aren't always as expected, as displayed here. 

This is because the V-Groove/Deboss/Pen is placed using the default parameters which mirror that of the bottom layer, rather than being an offset from the top mat that we're trying to flow around. 

You could spend quite some time trying to adjust the V-Groove, Deboss, or Pen parameters trying to get it to line up properly, but the instructions below show an easier way.

This lesson shows how to create a V-Groove, Deboss or Pen object to follow closely around a template shape.

Place a three layer 4 x 5 #314 Camelback Flare template into the FrameShop Design Editor.    

Click on the Properties tab.

Make the middle layer Reveal value .5” (1/2"), and the bottom layer Reveal value .25” (1/4"). The middle layer reveal is the distance from the template to place the V-Groove/Deboss/Pen object.

Bring into Trace via the Right-Click Menu or from the Cut Preview Screen.