Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Remnant Trimming

Select the desired remnant trimming direction on the CMC Z1 and Z (9000z) from the Remnant Trimming dropdown control. This will trim off the remaining section of the matboard to make it easier to store the remaining pieces for future use.   

...

Remnant Trimming: Vertical

Set Remnant Trimming to Vertical to set the default to cut the remnant matboard off vertically.

Click the Set Advanced Options button on the Cut Preview to access the Advanced Outside Options

Set Remnant Trimming to Vertical.

The design will cut and trim off the remnant matboard vertically.

Set the Default for Cutting the Outside 

The default setting for Cutting the Outside can be set in the Admin > Editor section.

Set the Default for 90 Degree Outside Cut

The default setting for 90 Degree Outside can be set in the Admin > Cutting section.

Set the Default for the Advanced Options

The default setting for the Advanced Options can be set in the Admin > Cutting section.

Set the Default for Remnant Trimming

The default setting for the Remnant Trimming can be set in the Admin > Cutting section.