This FrameShop Online Help System is for an older Version of FrameShop.+">This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 6 Next »

Vertical Home for V-Grooves

The Vertical Home defines the global vertical placement of objects cut with the blade cartridges. 

V-Groove Cuts too Far Up when Not Cutting the Outside: Bottom Border too Big

Adjust the Vertical Home if the V-Groove is cutting too far up when you are not cutting the outside of the mat. This is measured on the cutting side of the mat, from the bottom edge of the mat to the object.

The V-Groove is cutting too far up, making the bottom border too big.

Decrease the Vertical Home.

The V-Groove will now cut in the correct place.

V-Groove Cuts too Far Down when Not Cutting the Outside: Bottom Border too Small

Adjust the Vertical Home if the V-Groove is cutting too far down when you are not cutting the outside of the mat. This is measured on the cutting side of the mat, from the bottom edge of the mat to the object.

The V-Groove is cutting too far down, making the bottom border too small. 

Increase the Vertical Home.

The V-Groove will now cut in the correct place.

Vertical Home Troubleshooting

Alternatively, adjust the Vertical Home on the Troubleshooting Screen. Make sure that you only have a V-Groove on the screen. 

Adjusting the Vertical Position for Non-Blade Cartridges

To adjust the Vertical placement of the non-blade cartridges, (Deboss, Pen or Vinyl tools), see Vertical Adjustment.

  • No labels