">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 8 Next »

Change to the 90 Degree Blade Cartridge

  • The 90° blade cartridge is labeled 90° on the end and is green. 

  • Push blade cartridge release down to eject the current blade cartridge.

  • Turn 90 degree cartridge over and reinsert into the head with the blade facing the CMC board and the notch on the back of the cartridge facing the head, until it clicks into place. It can only be inserted one way.

  • Turn cartridge over and reinsert into the head with the blade facing the CMC board and the notch on the back of the cartridge facing the head, until it clicks into place. It can only be inserted one way.

  • If there is side-to-side movement of the blade in the blade cartridge, or if chunks have been cut out of it, then it is time to replace the blade cartridge.

  • No labels