">
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 38 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Horizontal Home for Openings Definition

  • The Horizontal Home defines the global horizontal placement of objects cut with the blade cartridges when not cutting the outside of the mat. 

  • This is measured from the inside of the bevel to the edge of the mat.

  • This is viewed as it cut on the machine, i.e., from the back if cutting from the back, or from the front if cutting from the front.

Opening Cuts too Far to the Right when Not Cutting the Outside: Horizontal Border too Big

Problem:

  • The opening is cut too far to the right Horizontally.

 Horizontal Home Definition

The Horizontal Home controls where the opening is cut Horizontally.

Resolution:

  • To adjust, click plus/minus on the field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

Opening Cuts too Far to the Left when Not Cutting the Outside: Horizontal Border too Small

Problem:

  • The opening cut cut too far to the left horizontally.

 Horizontal Home Definition

The Horizontal Home controls where the opening is cut Horizontally.

Resolution:

  • To adjust, click plus/minus on the field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

See Also: Horizontal Home Troubleshooting

See Also: Adjusting the Horizontal Position for Non-Blade Cartridges

  • No labels