">
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 21 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Crease Cartridge Configurations

  • The Crease Cartridge creases the material to make folding it easier when making Boxes.

  • This is viewed from the front of the mat.

Crease Tab

  • Select the Deboss Tab on the Configurations screen. 

  • Select the Crease Cartridge.

  • Crease Cartridge

Crease Exterior Backup is too Long

Problem:

  • The Crease Exterior Backup is too Long.

 Exterior Backup Definition

The Exterior Backup controls where the blade plunges into the matboard on the exterior cut. 

If the Exterior Backup is too short, it can leave a hook in the corner.

Exterior Backup cuts into the matboard, not the fallout.

The Exterior Backup field is marked with a Green Arrow.

Resolution:

  • Decrease the Exterior Backup.

  • See Exterior Backup for additional information.

Crease Exterior Backup is too Short

Problem:

  • The Crease Exterior Backup is too Short.

 Exterior Backup Definition

The Exterior Backup controls where the blade plunges into the matboard on the exterior cut. 

If the Exterior Backup is too short, it can leave a hook in the corner.

Exterior Backup cuts into the matboard, not the fallout.

The Exterior Backup field is marked with a Green Arrow.

Resolution:

  • Increase the Exterior Backup.

  • See Exterior Backup for additional information.

Crease Exterior Overcut is too Long

Problem:

  • The Crease Exterior Overcut is applied too Long.

 Exterior Overcut Definition

The Exterior Overcut controls where the blade retracts from the matboard on the exterior cuts.

Exterior Overcut cuts into the matboard, not the fallout.

The Exterior Overcut field is marked with a Red Arrow.

Resolution:

  • Decrease the Exterior Overcut.

  • See Exterior Overcut for additional information.

Crease Exterior Overcut is too Short

Problem:

  • The Crease Exterior Overcut is applied too Short.

 Exterior Overcut Definition

The Exterior Overcut controls where the blade retracts from the matboard on the exterior cuts.

Exterior Overcut cuts into the matboard, not the fallout.

The Exterior Overcut field is marked with a Red Arrow.

Resolution:

  • Increase the Exterior Overcut.

  • See Exterior Overcut for additional information.

Crease is the Wrong Size

Problem:

  • Crease is applied at the Wrong Size.

 Opening Adjustment Definition

The Opening Adjustment controls the size of the opening.

Resolution:

  • If cut too small, increase the Opening Adjustment.

  • If cut too large, decrease the Opening Adjustment.

  • See Opening Adjustment for additional information.

Crease is Applied at the Wrong Depth When Using a SKU

Problem:

  • The Crease is applied at the Wrong Depth When Using a SKU.

 Depth Bias Definition

The Depth Bias calculates the proper Blade Depth when a SKU is selected for the matboard.

Resolution:

  • Cut too shallow, increase the Depth Bias.

  • Cut too deep, decrease the Depth Bias.

  • See Depth Bias for additional information.

Troubleshooting Button 

  • Select this topic to see information on editing with the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview. 

Set Box Defaults

  • Set up the Box Defaults for the Crease cartridge in the Admin Editor section of the software.

  • No labels