Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 34 Current »

Aborting a Cut

  • The Emergency Stop Button is located on the lower left lower corner of the board, sometimes on the Control Panel.

  • Hit the Emergency Stop Button to immediately abort the current cut and disengage the motors. 

Restart After Aborting a Cut

  • To restart cutting, pull out the Emergency Stop Button and close and reopen the FrameShop software.

  • You will be asked to Align the Head before cutting again. 

  • See Align the Head for instructions on how to Align the Head.

  • No labels