">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 8 Next »

Cutting a Box

  • When you have the box design entered, you can bring it to the Cutting Preview in order to cut it.

Cut the Box

  • Click on Cut on the Box editor to bring the box design to the Cutting Preview.

  • Place the sheet of cardboard or other material onto the CMC. Make sure that the sheet is large enough for the design being cut.

  • Align the Head and click Cut.

  • Install the Deboss/Crease cartridge when prompted, select the correct blade depth, and click Continue.  

  • Install the 90° Cartridge when prompted and click Continue.

  • After the design has finished cutting, carefully remove the box design from the sheet.

  • Fold the pieces along the Deboss/Crease lines as instructed.

  • Some boxes have fold tabs, and some boxes require hot glue or other material to adhere the sides together.

  • The box design is finished. This shows the corner protector in place on a corner of a piece of framed artwork.

Walk-Through Box Assembly

  • No labels