Please box up the following three items for return |
|---|
Please use your original CMC box to box up the following four items into one box. If you do not have your original packaging the box the new CMC arrived in can be used. |
Head Removal | |
|---|---|
Caution: Head appearance may vary from model shown, but the connections are the same. Do not pick up head using the blade depth knob or the head cover. Pick up the head by holding the “D-Shaped” upper and lower head plates. If the motors are engaged, click reset motors button on the cut preview and click OK on the release motors prompt. | |
Press the 0 on the rocker switch on the back of the ECU to turn off the ECU. | |
Push blade cartridge release down to eject the blade cartridge. Turn off the air. | |
Remove the two gantry covers by unscrewing the screws that hold them in place and set them aside. | |
Move the gantry to the right side of the board until the foot block is off of the board. | |
Disconnect the head power plug (square connection) from the head grabber arm. | |
Disconnect the air to the head by untwisting the two air fittings. | |
Remove the two 5/32” screws and set aside. | |
If present, remove the Head Assembly Power Cable Strain Relief from around the base sides of the Head Power Plug connection. | |
Roll the head down the gantry until it rolls off the gantry, taking care not to drop it. Replace the two 5/32” screws into the head. | |
Removing the ECU/Driver Pack | |
|---|---|