">
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 14 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Crease Cartridge Configurations

The Crease Cartridge creases the material to make folding it easier when making Boxes.

Crease Tab

Below is a list of support documentation for editing the configurations of the Crease Cartridge on the Crease Tab.

Crease Exterior Backup is too Long

Problem:

  • The Crease Exterior Backup is applied too Long.

Resolution:

  • Adjust the Crease Exterior Backup. Select this topic to see information on editing the Exterior Backup.

  • This is viewed from the front of the mat.

Crease Exterior Backup is too Short

Problem:

  • The Crease Exterior Backup is applied too Short.

Resolution:

  • Adjust the Crease Exterior Backup. Select this topic to see information on editing the Crease Exterior Backup.

  • This is viewed from the front of the mat.

Crease Exterior Overcut is too Long

Problem:

  • The Crease Exterior Overcut is applied too Long.

Resolution:

  • Adjust the Crease Exterior Overcut. Select this topic to see information on editing the Crease Exterior Overcut.

  • This is viewed from the front of the mat.

Crease Exterior Overcut is too Short

Problem:

  • The Crease Exterior Overcut is applied too Short.

Resolution:

  • Adjust the Crease Exterior Overcut. Select this topic to see information on editing the Crease Exterior Overcut.

  • This is viewed from the front of the mat.

Crease is the Wrong Size

Problem:

  • Crease is applied at the Wrong Size.

Resolution:

  • Adjust the Crease Opening Adjustment. Select this topic to see information on editing the Opening Adjustment.

  • This is viewed from the front of the mat.

Crease is Applied at the Wrong Depth When Using a SKU

Problem:

  • The Crease is applied at the Wrong Depth When Using a SKU.

Resolution:

  • Adjust the Crease Depth Bias. Select this topic to see information on editing the Depth Bias.

Troubleshooting Button 

  • Select this topic to see information on editing with the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview. 

Set Box Defaults

  • Set up the Box Defaults for the Crease cartridge in the Admin Editor section of the software.

  • No labels