">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Quick Calibration Opening Adjustment

  • Measure the width of the opening from the cutting side to make sure it is 2”; this example was cut from the back.

Contents:

 Opening Adjustment General Definition

The Opening Adjustment controls the size of the Opening cut or Object applied with non-blade cartridges.

If the Opening is cut Too Large, Decrease the Opening Adjustment.

If the Opening is cut Too Small, Increase the Opening Adjustment.

See: Opening Adjustment for Openings Configurations

See: Opening Adjustment for Drops Configurations

See: Opening Adjustment for Outsides Configurations

See: Opening Adjustment for V-Grooves Configurations

See: Opening Adjustment for Deboss Configurations

See: Opening Adjustment for Pens Configurations

See: Opening Adjustment for Vinyls Configurations

See: Opening Adjustment for Creases Configurations

  • No labels