This FrameShop Online Help System is for an older Version of FrameShop.+">This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 22 Next »

Cut a Mat

These are the steps for cutting a mat.

Cutting a Mat

The screen indicator will display if you are cutting from the back or the front of the mat.

Place the matboard on the CMC with the front of the mat facing the board when cutting from the back and with the front of the mat facing the user when cutting from the front. 

Check for Clamp Interference on the CMC Z1 and Z (9000z), and adjust the finger-clamps accordingly.

Click the Cut button on the Cutting Preview Screen.

If the motors on the CMC are disengaged, the user will be prompted to Align the Head. 

Change the Blade Cartridge and Blade Depth as prompted, and click OK. 

After the Head is Aligned, the desired Blade Cartridge inserted and the Blade Depth adjusted as prompted, the CMC will begin to cut. 

  • No labels